How To Replace The Crusher Liner

Replace the frame lining plate, such as old liner board can not get down, gas cutting, and the frame surface is clean.

Replace the frame lining plate, such as old liner board can not get down, gas cutting, and the frame surface is clean. On the back of lining plate of new casting concrete, is 500 - 600, cement and sand, scale is at the mass ratio of 1:3 mixture. Before casting, lining plate to grind, make concrete and it firmly together.

Then, after casting concrete must be trimmed, the steel lining board and stand close to the back, and must be after the concrete fully cured and dried before being put into use, otherwise affect the service life.

Replacing the broken cone lining, lining to avoid damage in cutting cone plate process. When the cone lining plate installed, the adjustment ring cone at the lower part of the lower lining, keep the gap between 1 - 2 mm between the plate and the cone. Lining the top installed, should be first nut is installed, and then cast zinc alloy. Before casting, cone and plate pre hot 60 - 80 ℃, gap liner joints should be plugged with asbestos and clay, in order to avoid leakage of zinc alloy. Lining board finished alloy, with a compression nut and locking plate, which is tightly fixed.

Pre Article:Gold Ore Crusher Equipment Recommended

Next Article:Impact Crusher Development History